How to use and ways to mount to shoe
We made these so they are very simple to use.
- Find a soft surface like moist sand, or a soft mud,snow works great too.
- Press with your foot into the soft surface.
Remove the Bigfoot Tracks and it should like this
-You can make one, or several of them.
-If you are wanting to make people believe they are real, you do not need a lot of tracks.
Another use is to fill them with sand, and then turn upside down.
-Fill with sand.
-A moist sand will work best!
-Turn upside down.
- Make a trail of Bigfoot Tracks.
Here is the simplest way to mount your Bigfoot Tracks to a shoe or boot.
-First get an old pair of shoes or boots
-Second buy some foam from your
local hardware store.Make sure its
the type that gets hard and is sandable
-Third fill the bottom of the Bigfoot Track
with the spray foam about an inch deep
-Fourth place the shoe or boot in the area you sprayed and press down
-Fifth is fill the area around the shoe or boot with foam and its up to you on how much you want to cover up the shoe or boot.
Since these were old shoes and most likely will
only be used for this purpose I filled mine up over the shoe. Let it sit for the time it calls for and when hardened all you need to do is put on the shoe.
